Flat Wire Belting
Standard Duty Flat Wire Belting
Standard duty belts are normally equipped with clinched edges to prevent shrinkage on the rods, but can also be furnished with button-head welded edges.
Heavy Duty Flat Wire Belting
Heavy duty belts are normally equipped with button-head welded edges but can also be furnished with clinched edges to prevent shrinkage on the rods.
Key-Turn Heavy Duty Radius Belting
Key-turn belts perform like straight run belts but have the capability to make left or right hand turns up to 180 degrees. The minimum belt turning radius is equal to 2.2 times the belt width, this is measured on the inside radius of the belt. In a turn the outside edge receives all the stresses but with the addition of reinforcing links the load carrying capacity is greatly increased.
These reinforcing links can be supplied on either side or both.
Versa-Link
This easy-to-install flat wire belt can be joined using link rods in as little as 30 seconds. With an edge finish that is flush with the belt and up to 81% open area, the Versa-Link belt is easy to clean and provides maximum flow through capabilities for heating and cooling operations.
| Belt Name | Sizes (inches) | Material | Benefits | Few Applications |
|---|---|---|---|---|
| Versa Link | Pitch: 3/8" and ½" Belt Thickness: 0.16" Belt Width: Up to 150" |
|
|
|
| Standard Duty Selvage | Flat Strip (round edge): 3/8" wide x 0.046" thick Connector Rod: 0.120" diameter (11 gauge) Belt Width: 3" - 240" Mesh Sizes: 1" X 1" ½" X 1" ¾" X 1" ½" X 1" Modified True ½" X ½" |
|
|
|
| Heavy Duty Selvage | Flat Strip (round edge): ½" wide x 0.062" thick Connector Rod: 0.192" diameter (6 gauge) Belt Width: 3" - 192" Mesh Sizes: 1" X 1" ½" X 1" ½" X 1 Modified |
|
|
|
| Key-Turn Heavy Duty Radius | Flat Strip (round edge): ½" wide x 0.062" thick Connector Rod: 0.192" diameter (6 gauge) Belt Width: 7" - 48" Mesh Sizes: 1" x 1" ½" x 1" |
|
|
|
Sprockets and other drive components can also be supplied as per request. Please contact us for more detailed specifications regarding our flat wire belts and corresponding sprockets.
Flights and Special Attachments
If your process involves handling moving material or products on an incline, you can consider using flights on your belt. Various styles of flights can be provided including lane dividers, edge guards, and compartments upon request. Custom flights can also be fabricated if needed and can be welded to the belt or attached using flight clips. Special attachments can include edge guards and attachments to raise products above belt. Custom attachments can also be designed for your special applications.
Print This Page